Remove 2 screws-B and remove the Optical filter unit2. Marker comes this top side. Two protection systems are pro- vided. Mark the polarizer units as they are removed from the optical unit so that they may be reassembled in the same location from which they were removed. Remove 6 screws-A and remove the Polarized glass units. Remove 4 screws-B, remove the plate and remove the Condenser lens. Type-R and Type-L Each Optical unit must combine and use the specific Optical parts.
Remove 3 screws-A and remove the Fan R Unit. Each adjustment requires ball allen wrenches and slot screwdrivers. Adjust green grid pattern to sharp focus by pressing Focus buttons on the projector or remote control unit. Remove screw-C and remove the Stopper E. Do not attempt to adjust the following adjustments except requiring the readjustments in servicing otherwise it may cause loss of performance and product safety. Check the fuse as following steps.
Remove screw-B, remove the plate A and remove 5. File with the service manual No. Fan R Unit removal and Disassemblies. Do not hold the Projection lens Fig. Remove 11 screws and remove the Optical base top. Remove 2 screws-A, remove 2 screws-B and remove the Power Unit. Remove 2 screws-A and remove the Condenser lens unit.
Remove 4 screws and remove the Mounting cover lens-A. Remove the fuse and the fuse holder cover forward. Set the motorized lens shift to the center position horizontal and vertical with Lens Shift Button. If the shade appears on the left or right of the screen, adjust in the following procedure. Remove 4 screws-A and remove the Speaker box-A. Do not touch the part on hot side primary circuit or both parts on hot and cold sides secondary circuit at the same time.
Remove the Terminal slots unit upward. Remove 2 screws-A ,remove 2 screws-B, remove screw-C,remove screw-D and remove the Terminal Board Component. Remove 4 screws-A, remove screw-B and remove the Switch power supply 25V unit. Remove screw-E, remove the plate and remove the Optical filter upward. Lamp Ballast Units 1-2 1. Remove 4 screws, remove the Control Button and remove the Control Board.
Integrator lens is bonded on the Holder. If this indicator lights yellow, replace the lamp with a new one promptly. Remove 2 screws-B and remove the Lamp Fan net Board. Remove the fuse and the fuse holder cover upward. Screws Expression Following steps show the basic procedures, therefore unnecessary step may be Type mm Diameter x Length ignored. Remove 4 screws-A and remove the Mirror units. There is no guarantee of the same lifetime for each lamp.
Components indicated by a mark in this parts list and the circuit diagram show components whose value have special significance to product safety. Loosen the screw-D and remove the Safety Clamp. Should Air Filter become clogged with dust particles, it will reduce Cooling Fans' effectiveness and may result in internal heat build up and adversely affect life of a projector. Bus signals When the lamp cover is removed are correct. Unhook the holder 4 places and remove the Integrator lens. Remove 4 screws-B and remove the Speaker box-B.
Remove 3 screws-A and remove the stoppers. Remove 4 screws-G and remove the Handles. Remove 4 screws B and remove the 2 Plates. When ordering a Projection Lamp, give the following information to the dealer. Remove 2 screws-A and remove the Duct D. The parts specification of resistors, capacitors and Resistor Reading coils are expressed in designated code.