I guess it's possible that ChessBroadBand has set a custom admin password, but because there is a printed Access Key, that's probably the default. I don't have time now but I might have a play. Maybe you could write to Starhub regarding this matter, as they have to check on their end. Below the table are also instructions on what to do incase you , need to , or the password reset doesn't work. I suggest you put up an extension router or dongle.
Connect your device to the router. The router addressing information should be entered next. So I have been looking for hours to find the login to this router using upper and lower case and have got absolutely no where at all and have tried factory reset as well. Try to connect using a computer that has an ethernet cable connected to the router. Here, Changed the wireless channel either on 1, 6 or 11 then apply the settings.
What if my Technicolor router or network stops working after the configuration change In case you by mistake make some change that breaks your Technicolor home network, you can always go back to zero by following the generic. Take a paperclip, pen or anything pointed to press into the reset pinhole on the back of the router. Do note that the ports for each services is fixed. I've reset it several times since but still to no prevail. It was admin and serial number. Hackers know this and always try to access your network with these preconfigured passwords.
So that mean all your devices like wireless router, firewall needs to change to 10. I am not sure if I will swap my old router for this one even though it has Class-N WiFi. Thanks, Matt Thanks for responding. You are now given the option to change the wireless settings. Obviously when the Hathway is giving us the Router for free, one cannot expect much from it. The next page is an overview of the configuration. I tried logging into the gateway, with a few different logins I know eg admin-admin, but none I knew worked.
Enter the user name and password for your combination modem-router. Once plugged in, wait for the router's lights to turn on. Enter the new details and get connected. Put in the user name and password provided to you by tesco or you can check the bottom or back of the router for default access. Be careful when you configure your router so that you don't break the network. Most router login page is set as default and no need to do any input, just click on Login.
Are you accessing locally or via wan?? If you are unsure of your username and password, these were provided in your welcome email. If unable to access, then you can do a reset. But when I try to log in to Technicolor it will not accept any login info. It should be in a sticker at the bottom of the router. And we use the serial number as the admin user's default password. Without other devices nor walls that has sub material that can cause wireless interference.
Are you sure you are reading the Access Key correctly? But recently Ive been having trouble logging in, I googled the problem and all responses said I had to update the ports so they are synced with my Xbox. Enter your broadband connection username and password. This will reset to default login. The other approach is to go the dhcp setup. Is that whatb you mean with smb? But recently Ive been having trouble logging in, I googled the p.
Then you will have to reset the settings to default. Test this by browsing to and performing a search. Also, are you sure you are doing a full factory reset? The reason I have come here for a possible solution is that I have a dump of the flash chip from the board. My primary equipment is under lock and key in a bedroom when I am not there or if there are visitors and I am away from that room or access to it. Once you have accessed the user interface.
At this point, you will need to connect and log in to the router. Hathway mostly uses Technicolor routers, mainly in Hyderabad. Thomson moved from that long long ago but Telstra decided it was too hard to retrain their techs. It is ftp that is failing. Keep the button pressed in for 7-10 seconds.