Do not jump wakes with another boat, which could result in se- or waves. Modifications to your watercraft may reduce safety and reliability, and render the water- craft unsafe or illegal for use. Does the starter relay switch function properly? Apply battery voltage to the starter motor directly. Pump out the engine oil with a commercially available Fluid Evacuator from the oil filler hole and drain pipe, to drain the oil tank and oil pan. Check the start switch, the engine stop switch, and the engine shut-off switch for proper operation. These can be diagnosed by a compression test, or by tracing top-end noise with a sounding rod or stethoscope.
Spray the lubricant into joint hole for 3 seconds. Your WaveRunner requires periodic checks and lubrication to remain in efficient condition, so download a maintenance guide and keep track of all service intervals. Yamaha dealer repair the watercraft. Reinstall the drain pipe cap and tighten it. Screw the spark plug in the cylinder head by hand to prevent cross-threading.
Scan constantly for people, objects, and other watercraft. You could any debris or weeds, which may have col- also damage the shift mechanism. Check the ground line of the starter relay switch. Select a wide area to learn in, where there is good visibility and light boat traffic. The spark plug cap and ignition coil are integrated.
Have a Yamaha dealer replace the battery. Apply engine oil to the O-ring and threads of a new oil filter cartridge and install the filter using the filter wrench. Do not attempt to modify this watercraft! Any wrong connection could dam- 2 Replace the blown fuse with the spare age the electrical system. Operate defensively at safe speeds and keep a safe distance away from people, objects, and other watercraft. Check the jet stator inner wall for scratches. It is worth the time spent to ensure safety and reliability. The front storage compartment is located at the bow.
Always properly dispose of mended by Yamaha because it can cause gasoline-soaked rags. A full vided, and keep their feet on the floor of the wetsuit can also protect against hypothermia footwell. Add the recommended engine oil into the oil tank through the filler hole until oil is on the dipstick. The following items require some mechanical knowledge. These materials should give you an understanding of the watercraft and its operation. Also, check that the clamp is installed on the oil tank securely. Coast Guard injure you in others.
Install the joint hoses into the clip s properly. There's a lot that goes into owning a WaveRunner, but it should also be a rewarding experience. Install a new air filter into the housing base properly. Use the buddy system—operate with someone nearby. See page Switches 31 for more information. Coast Guard for more information.
. Place a shop towel around the oil filter cartridge to avoid spilling the engine oil. Relay Coil Power Input Line Inspection Check the power input line of the starter relay switch. The tools provided in the tool kit are suf- tempting any modifications. To remove the seat: Pull the seat latch up, and then pull the seat off.
If you charge the battery Be careful not to place the battery on its yourself, be sure to read and follow the in- side. Operation of the water- that there is no traffic or other obstacles, ap- craft must be in accordance with the rules ply enough throttle to raise the skier. If there check the watercraft. Do not operate the engine at full throttle for at least 1 minute after the engine has been restarted. Perform the same lubrication procedure for joint hole. Starter Motor Inspection Remove the safety lanyard switch from the engine stop switch. Use the tachometer in the multifunction informa- tion center to check the trolling speed.