Calculate the drive belt slack by To check the drive belt slack subtracting the measurement not- 1. Fuel tank cap page 3-7 3. Stabilize the rear of the motorcycle dealer, whose skilled technicians have by using a motorcycle stand or, if. Clutch lever page 3-6 2. Left handlebar switches page 3-6 7. The fuel tank has old dead gas.
Do not park the motorcycle on a slope or soft ground, otherwise it may fall over. Air filter check hose 2. Press both the set button right Fuel gauge Clock and the mode button left simulta- The fuel gauge indicates the amount of neously until the hours and min- fuel in the fuel tank. The motorcycle should not be ridden until checked by a Yamaha dealer. And make sure you put the right wire on the right plug, which shouldn't be a problem if you only remove one at a time. The motorcycle should not be ridden until checked by a Yamaha dealer. Loosen the air filter joint clamp 4.
This, in addition to extensive research, is how Clymer repair manuals achieve an unmatched level of detail, accuracy and clarity to guide the reader through each service, troubleshooting and repair procedure. Severely discharged or a damaged battery should have 12. These manuals covers all the topics like: Engine, General Information, Tranmission, Chasis, Lightning , Steering, Seats System, Clutch, Suspension, Locks, Brakes, Lubrication, Electrical, Frame Fuel System, Battery and other topics. Make sure tact a Yamaha dealer immediately and 0—90 kg 0—198 lb : Front: that the total weight of the cargo, rid- have the tire replaced. If tion and, if necessary, have a Yamaha necessary, adjust the brake light switch dealer adjust it.
Check for engine trouble codes. Good luck and have a wonderful day. Take an air compressor with a blow gun and blow out the spark plug ports, so no dirt or debris gets into the cylinder. If you are on dial-up please message me first and i will see if the file is small enough to download via dial up connection Tags: pdf Comments. Install the oil check bolt, and then Tightening torque: check hole, remove the oil filler tighten it to the specified torque.
Install the headlight unit by install- from a lit headlight bulb, and do not ing the screws. Clutch lever page 3-7 6. Fuel tank page 3-7 2. Record the information on this label in the space provided. Shift the transmission into first shown in the table below. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders. Keep the clutch lever pulled.
Battery The engine turns over The battery is good. Air filter element page 6-15 7. It'll make it a little easier to remove and replace the plugs. A slight tilt to the side can result in a false reading. Good luck and have a wonderful day. Avoid any contact with battery damage. Remove the air filter element by removing the screws.
Electronic fuel injection fuse Replacing the fuses Specified fuses: 5. Record the information on this label in the space provided. Always tighten the locknut against the adjusting nut, and then tighten the locknut to the specified torque. Shift pedal page 3-7 5. Do not attempt this model, and they must be se- dealer replace the wheel. The panel shown needs to be removed Since heat and deposits will cause any to perform some of the maintenance spark plug to slowly erode, the spark jobs described in this chapter.
Fuel tank filler tube Fuel tank capacity: 2. Keep in mind that the charged. Severely discharged or a damaged battery, should have 12. Place a new headlight bulb into position, and then secure it with the bulb holder. To apply the rear brake, pull the lever toward the handle- brake, press down on the brake pedal.